SONY DCR-PC103E l'instruction d'utilisation télécharger (Page 257 de 316)

Les langues: Français encore 1
  • Anglais
Pages:316
Sur le site, vous pouvez voir la version complète du document et le télécharger en format PDF.
Page 257 de 316
257
Troubleshooting
Dépannage
If you run into any problem using your camcorder, use the following table to troubleshoot the
problem. If the problem persists, disconnect the power source and contact your Sony dealer. If
“C:
ss
:
ss
” appears on the screen, the self-diagnosis display function has been activated. See page
265.
During recording
Symptom
Cause and/or Corrective Actions
• The POWER switch is not set to CAMERA.
c
Set it to CAMERA (p. 37).
• Your camcorder automatically turns off to prevent the battery
pack from running out and to protect the tape when your
camcorder has been in recording standby for more than
5 minutes.
c
Set the POWER switch to OFF (CHG) and then to CAMERA.
• The tape has run out.
c
Rewind the tape or insert a new one (p. 12, 53).
• The write-protect tab is set to SAVE.
c
Use a new cassette or slide the tab (p. 284).
• The tape is stuck to the drum (moisture condensation).
c
Remove the cassette and leave your camcorder for at least
1 hour to acclimatise (p. 292).
• Your camcorder automatically turns off to prevent the battery
pack from running out and to protect the tape when your
camcorder has been in recording standby for more than
5 minutes.
c
Set the POWER switch to OFF (CHG) and then to CAMERA.
• The battery pack is dead or nearly dead.
c
Install a fully charged battery pack.
• The viewfinder is not extended.
c
Pull out the viewfinder (p. 44).
• The viewfinder lens is not adjusted.
c
Adjust the viewfinder lens (p. 44).
• STEADYSHOT is set to OFF in
in the menu settings.
c
Set it to ON (p. 236).
• Manual focus is set.
c
Press FOCUS to enable the autofocus (p. 83).
• Shooting conditions are not suitable for autofocus.
c
Adjust to focus manually (p. 83).
• The LCD panel is open.
c
Close the LCD panel.
(continued on the following page)
START/STOP does not operate.
The power goes off.
The picture in the viewfinder is not
clear.
SteadyShot does not work.
The autofocusing function does
not work.
The picture does not appear in the
viewfinder.
— Troubleshooting —
English
Types of trouble and how to correct trouble
Sample